A versatile Digicounter suitable for timing frequency period and radioactivity measurement. A built-in high stability crystal controlled oscillator ensures a typical accuracy of 0.005% on all measuring ranges. The period measurement and display function enables very low frequencies to be measured rapidly with a high degree of accuracy. It also allows triggered timing of trolley speeds (etc.) to be performed using a single light gate; and by shorting the period input infinite radioactivity or frequency counts may be obtained.Full Notes for Use included.Radioactivity:Inputs: E.H.T BNC connector for a G.M. tube. Supply voltage adjustable from 300 to 500VCounting time: 1 10 100 or 1000 seconds and infinity. Can be set to take a single or a continuous series of readings each being displayed for 3 seconds before the next is takenRate: Obtained by dividing the count reading by the counting timeSpeaker: Output will feed into a speaker of any impedanceTiming Ranges: 0 to 99.9999 x 0.1ms; 0 to 999.999 x 1ms; 0 to 9999.99 x 0.01s (10ms); 0 to 99999.9 x 0.1s (100ms)Accuracy: Better than 0.005% ±1 countGating: (1) By manual front panel stop/start switch;(2) By make or break input sockets; (3) By triggering timing stop/start inputs. Output 2V and 6V a.c. at 0.5A for light gate or similar ampsFrequency Inputs:Low frequency d.c. to 3MHz minimum (5MHz typical). Will operate with T.T.L inputs light gates etc.High frequency capacitively coupled 30Hz to 3MHz minimum (5MHz typical);High gain input voltage required 0.8mV r.m.s. from 30Hz to 20kHz; recommended microphone - high impedance dynamic typeInput impedance: 20O for inputs (1) and (2); 100kO for input (3)Accuracy: Better than 0.005% -+ 1 countPeriod:Timing intervals: 0.1 1 10 and 100msThis device is compliant to EN61010-2010 with certificates available on request.Related products include:Geiger-Muller Tube (B8H27155) & Geiger-Muller Tube Holder (B8A49724)Radioactive Source Handling Tool (B8A49608)Radioactive Sources (B849589 B8A49578 or B8A49591)Light Gate (B8H27623)