An electronic controlled water still from Stuart which is capable of producing a high quality distillate. This model gives outputs of 4 litres/hour single distilled water. The high quality borosilicate glassware coupled with silica sheathed heaters gives pyrogen free distillate of the highest purity from virtually any raw water supply (conductivity less then 2µs/cm).The still has a unique double pitch coil condenser which produces a low temperature distillate around 25-35°C allowing immediate use. The unique condenser design ensures that the droplets of distilled water remain in contact with the cooling coil for the longest possible time ensuring maximum energy transfer. This produces cold distilled water ready for immediate use and pre-heats the boiler feed to increase efficiency.A flow sensing device will detect any reduction in the flow of cooling water to below the required level and will turn off the still before it can overheat. Sensing the flow of cooling water rather than its pressure is safer and allows the still to run normally on low pressure supplies down to 3psi (20kPa). As a fail-safe device there is an over-temperature thermostat mounted in the boiling chamber.A level control device automatically turns off the heater and water supply when the reservoir is full. The control is a simple and effective system which can be fitted to virtually any type of reservoir vessel. It will turn the still off when the reservoir is full and restart it when the level in the reservoir drops as distilled water is removed for use making it fully automatic water purificationThe still has two safety cut-out devices for protection in the event of coolant or water feed failure.All glass construction allows rapid descaling using strong mineral acids. A built in ""clean"" function and integral acid addition funnel make the cleaning operation simple and safe with no need to dismantle any of the glassware. A large bore stopcock with PTFE key is fitted for easy draining of chemicals after cleaning. The Aquatron is very easy and safe to assemble and maintain. Both the acrylic safety screen and the cabinet lid are removable giving unrivalled access to the glassware components. Screw threads are incorporated on all water connections so hoses can be fitted and removed easily and safely without risk of breakage. Every Aquatron® water still is supplied with a reservoir level control.The still is easily installed and can be wall or bench mounted. It is supplied with easy to fit wall mounting bracket.Features push button switches for ease of operation.It can be used with pre-treated water by using a water feed kit (optional extra).Specification:Automated System - automatically turns off the heater and water supply when the reservoir is full. Output: 4 litres per hourPyrogen content: NilpH: at 20°C 5.0 to 6.5Conductivity: 1 to 2µS/cmbrResistivity: at 20°C Mohm /cm3Temperature: 25-35°CWater supply: 1 litre per minute 3 - 100 psiPower: 220-240V 50-60Hz 13A fusedDimensions: 550 x 240 x 410mm width x depth x heightAutomated Cut-offCan operate standing on the laboratory bench or be wall mounted.Supplied with easy to fit wall mounting bracket.